1. Clean the area that you wish to put your decal on.
2. Peel the paper with the lines on it off at a sharp angle. Be sure that the decal does not stick to this paper.
3. Line up your decal where you want it.
4. Start at one corner and begin pressing the decal to the surface while holding the other corner away from the surface. Continue to rub the decal on to the surface with side to side motion.
5. After the whole decal is on the surface. Rub the entire thing making sure that it is applied to the surface.
6. Start at a corner and start to peel the tape off of the decal at a sharp angle.
7. If the decal starts to stick to the tape stop and rub it down again.
8. Repeat #6.

1. Clean the area that you wish to put your decal on.
2. Figure out which side each flame is going on.
3. Start to peel the decal off of the paper where the part is that is going next to the battery door.
4. Line up the straight part of the decal with the battery door. But be sure not to cover the opening.
5. Begin pressing the decal to the surface with your thumb. Start to roll the paper under the decal. Continue to rub the decal on to the surface with a side to side motion.
6. Try and do one branch at a time.
7. After the whole decal is on the surface. Rub the entire thing making sure that it is applied to the surface.
8. Any small bubbles should disappear with time.

DIE-CUT EVLUTION FLAME DECAL INSTRUCTIONS

1. Clean the area that you wish to put your decal on.
2. Start with the right side set of flames.
3. Peel off the main part of the flame. The part that all of the other parts come out of.
4. Line up the bottom hump part of the decal about 1/8th" above the forward bottom screw hole. But be sure not to cover the opening.
5. Begin pressing the decal to the surface with your thumb. Continue to rub the decal on to the surface with a side to side motion.
6. Next do the bottom branch, middle branch, top branch and make sure not to cover any seams, writing or screw holes.
7. After the whole decal is on the surface. Rub the entire thing making sure that it is applied to the surface. Repeat 3-7 for the other side.
8. Any small bubbles should disappear with time.

ONE PIECE DECAL INSTRUCTIONS

DRAGON HEAD DECAL

1. Clean the area that you wish to put your decal on.
2. Lay out the 12 different pieces where you want to put them as shown.
3. Take a small piece of masking tape and tape each piece into place.
4. Next take a one inch wide piece of masking tape and put it across A1 in the center to hold it in place. This will give you a hinge evect.
5. Remove the small pieces of tape, leaving the center cross piece in place.
6. Fold one side of the decal across the middle
7. Start to peel the paper away from the back of the decal.
8. Peel it to about half way then cut the paper off.
9. Next you take the end of the decal in one hand and the squeegee in the other and begin to lay the decal down.
10. Squeegee the decal to your surface from the center out.
11. Go back over it with the squeegee making sure that it is secured to the surface.
12. Now lift the center hinge piece of tape off of the decal.
13. Fold the other half back across the decal to have the paper backing face you.
14. Peel the paper backing off.
15. Then repeat steps 9-11.
16. Go over the entire piece you just did then remove the tape at a sharp angel.
17. Now repeat steps 4 through 16 for pieces A2, A3, A4, A5, A6.  Then do it for B1, B2, B3, B4, B5, and B6.
18. If there are any tiny bubbles they should go away in a few days.